Get to know bearing better

Inspection of Bearings

Bearing Cleaning
 When bearings are inspected, the appearance of the bearings should first be recorded and the amount and condition of the residual lubricant should be checked. After the lubricant has been sampled for examination, the bearings should be cleaned. In general, light oil or kerosene may be used as a cleaning solution.

 Dismounted bearings should first be given a preliminary cleaning followed by a finishing rinse. Each bath should be provided with a metal net to support the bearings in the oil without touching the sides or bottom of the tank. If the bearings are rotated with foreign matter in them during preliminary cleaning, the raceways may be damaged. The lubricant and other deposits should be removed in the oil bath during the initial rough cleaning with a brush or other means. After the bearing is relatively clean, it is given the finishing rinse. The finishing rinse should be done carefully with the bearing being rotated while immersed in the rinsing oil. It is necessary to always keep the rinsing oil clean.

Inspection and Evaluation of Bearings
 After beng thoroughly cleaned, bearings should be examined for the condition of their raceways and external surfaces, the amount of cage wear, the increase in internal clearance, and degradation of tolerances. These should be carefully checked, in addition to examination for possible damage or other abnormalities, in order to determine the possibility for its reuse.

 The determination to reuse a bearing should be made only after considering the degree of bearing wear, the function of the machine, the importance of the bearings in the machine, operating conditions, and the time until the next inspection. However, if any of the following defects exist, reuse is impossible and replacement is necessary.
 
 (a) When there are cracks in the inner or outer rings, rolling elements, or cage.
 (b) When there is flaking of the raceway or rolling elements.
 (c) When there is significant smearing of the raceway surfaces, ribs, or rolling elements.
 (d) When the cage is significantly worn or rivets are loose.
 (e) When there is rust or scoring on the raceway surfaces or rolling elements.
 (f) When there are any significant impact or brinell traces on the raceway surfaces or rolling elements.
 (g) When there is significant evidence of creep on the bore or the periphery of the outer ring.
 (h) When discoloration by heat is evident.
 (i) When significant damage to the seals or shields of grease sealed bearings has occurred.